init minimal

.config/i3status/config

@@ -0,0 +1,71 @@
+# i3status configuration file.
+# see "man i3status" for documentation.
+
+# It is important that this file is edited as UTF-8.
+# The following line should contain a sharp s:
+# ß
+# If the above line is not correctly displayed, fix your editor first!
+
+general {
+        colors = true
+        interval = 5
+	color_good =     "#7cafc2"
+	color_degraded = "#dc9656"
+	color_bad = "#ab4642"
+}
+
+#color_good =     "#a1b56c" #light green
+#color_degraded = "#f7ca88" #light yellow
+#color_degraded = "#dc9656" #light orange
+#color_bad =      "#ab4642" #light red
+#color_good =  "#86c1b9" #light cyan
+#color_good =  "#7cafc2" #light blue
+#color_good = "#4A6EF"  #blue
+#color_degraded = "#85678F"
+#color_bad = "#FF1D1D" #red
+
+order += "ipv6"
+order += "disk /"
+order += "wireless _first_"
+order += "ethernet _first_"
+#order += "run_watch DHCP"
+order += "path_exists VPN"
+order += "battery all"
+order += "load"
+order += "tztime local"
+
+wireless _first_ {
+        format_up = "W: (%quality at %essid) %ip"
+        format_down = "W: down"
+}
+
+ethernet _first_ {
+        # if you use %speed, i3status requires root privileges
+        format_up = "E: %ip (%speed)"
+        format_down = "E: down"
+}
+
+battery all {
+        format = "%status %percentage %remaining"
+}
+
+tztime local {
+        format = "%Y-%m-%d %H:%M:%S"
+}
+
+load {
+        format = "%1min"
+}
+
+disk "/" {
+        format = "%avail"
+}
+
+path_exists VPN {
+   # path exists when a VPN tunnel launched by nmcli/nm-applet is active
+   path = "/proc/sys/net/ipv4/conf/tun0"
+}
+
+run_watch DHCP {
+   pidfile = "/var/run/dhclient*.pid"
+}