# i3status configuration file.
# see "man i3status" for documentation.

# It is important that this file is edited as UTF-8.
# The following line should contain a sharp s:
# ß
# If the above line is not correctly displayed, fix your editor first!

general {
        colors = true
        interval = 7 
        color_good = "#7cafc2"
        color_degraded = "#dc9656"
        color_bad = "#ab4642"
}

#color_good =     "#a1b56c" #light green
#color_degraded = "#f7ca88" #light yellow
#color_degraded = "#dc9656" #light orange
#color_bad =      "#ab4642" #light red
#color_good =  "#86c1b9" #light cyan
#color_good =  "#7cafc2" #light blue
#color_good = "#4A6EF"  #blue
#color_degraded = "#85678F"
#color_bad = "#FF1D1D" #red

order += "disk /"
order += "ipv6"
order += "wireless _first_"
order += "ethernet _first_"
#order += "run_watch DHCP"
#order += "path_exists ovpn"
order += "path_exists wgvpn"
order += "path_exists wg0"
order += "battery all"
order += "cpu_temperature 0"
order += "load"
order += "tztime local"

wireless _first_ {
        format_up = "W: (%quality at %essid, %frequency) %ip"
        format_down = "W: down"
}

ethernet _first_ {
        # if you use %speed, i3status requires root privileges
        format_up = "E: %ip (%speed)"
        format_down = "E: down"
}

battery all {
        format = "%status %percentage %remaining"
}

tztime local {
        format = "%Y-%m-%d %H:%M:%S"
}

load {
        format = "%1min"
}

disk "/" {
        format = "%avail"
}

#path_exists ovpn {
#   # path exists when a VPN tunnel launched by nmcli/nm-applet is active
#   path = "/proc/sys/net/ipv4/conf/tun0"
#}

path_exists wgvpn {
   # path exists when a WireGuard VPN tunnel is active 
   path = "/proc/sys/net/ipv4/conf/wgpia0"
}
path_exists wg0 {
   # path exists when a WireGuard VPN tunnel is active 
   path = "/proc/sys/net/ipv4/conf/wg0"
}
run_watch DHCP {
   pidfile = "/var/run/dhclient*.pid"
}

#update the following device path for temp1_input as needed
cpu_temperature 0 {
        format = "%degrees °C"
        path = "/sys/devices/platform/coretemp.0/hwmon/hwmon*/temp1_input"
}